REQUEST A QUOTE
English
Before using the Double Layer Terrazzo Tile Machine, it is essential to carry out comprehensive preparations to ensure efficient operation of the equipment and high-quality output of the product.
Preparation before operation
Equipment inspection
Before operating, be sure to conduct a thorough inspection of the machine. The inspection includes the integrity of each component and the stability of the fasteners. Special attention should be paid to the normal operation of the hydraulic system, electrical system and transmission components to ensure that the equipment is in the best working condition.
Raw material preparation
According to production requirements, an appropriate amount of terrazzo raw materials should be prepared. The raw materials used must be ensured to be dry and free of impurities to improve the quality of the final product. At the same time, the integrity of the mold and the accuracy of the size should also be carefully checked to ensure that the produced floor tiles meet the design standards.
Safety protection
During operation, appropriate personal protective equipment must be worn, such as hard hats, protective glasses and protective gloves. In addition, ensure that there are no idle personnel in the operating area to reduce the risk of accidents.
Precautions during operation
Start-up sequence
When starting the double-layer terrazzo tile machine, the order of starting the hydraulic system first and then the electrical system should be followed. Avoid sudden power on and off to prevent damage to the equipment.
Raw material delivery
When delivering raw materials, ensure that the mold is filled evenly and in appropriate amounts to avoid too much or too little raw materials. At the same time, keep the raw materials evenly distributed to ensure the consistency of the quality of the produced floor tiles.
Pressure control
During the process of pressing floor tiles, the pressure of the machine needs to be reasonably adjusted according to the hardness of the raw materials and the size of the mold. Excessive pressure may cause unstable quality of floor tiles, while too little pressure may damage the machine.
Temperature monitoring
During the operation of the equipment, it is necessary to pay close attention to the temperature changes of the mold and raw materials. Too high or too low temperature will have a negative impact on the quality of floor tiles and the service life of the machine.
Abnormal handling
If the machine makes abnormal sounds, vibrates or leaks oil during operation, it should be stopped immediately for inspection and contact professional technicians for repair to prevent the fault from expanding and affecting production progress and product quality.
Maintenance and care after operation
Cleaning the machine
After the operation, the dust and impurities on the surface of the machine should be cleaned in time to keep the equipment clean. At the same time, check the integrity of the mold and replace it in time if it is damaged.
Lubrication and maintenance
Regularly lubricate and maintain the transmission parts and hydraulic system of the machine to ensure the normal operation of the equipment. Check all fasteners and tighten them in time if they are loose.
Electrical inspection
Regularly conduct a comprehensive inspection of the electrical system to ensure that all electrical components are operating normally. If electrical components are found to be damaged or aged, they should be replaced in time.
Shutdown protection
When the machine is not used for a long time, it should be placed in a dry and well-ventilated environment to prevent the equipment from moisture or corrosion. At the same time, cut off the power supply to ensure the safety of the equipment.
